Enertec GE0610H – All-in-One Hybrid ESS, 6 kVA, 10.24 kWH

The Enertec Megatank GE0610H all-in-one ESS Solution

The modular all-in-one design integrates storage and charging, and the automatic switching of off-grid, grid-connected and diesel generators. The residential energy storage system consists of the following parts: solar charging controller, energy storage inverter, lithium battery & EMS.

The system supports a variety of working modes, and can give priority to the use of photovoltaic and energy storage to supplement energy supply load. It can give priority to the grid with load, photovoltaic supplement, energy storage battery as a backup power supply; at the same time, it supports seamless switching for on & off-grid operation; it can also be set up to switch charging function and intelligent mode charging with one-button.

Specifications – GE0610H

PV INPUT

Max.recommended DC power[kW]: 5.4kW
Max.DC voltage[V]: 250V
Max.charging current[A]: 70A
Max. short circuit current[A]: 80A
MPPT voltage range[V]: 65V – 245V
No. of MPP trackers: 1

AC INPUT

Nominal AC power [kW]: 8.4kW
Max. AC power [kW]: 13kW
Rated grid voltage (AC voltage range) [V]: 230V (175V – 265V)
Rated grid frequency [Hz]: 50/60Hz (45Hz – 65Hz)
Nominal AC current [A]: 38A
Max. AC current [A]: 59A

BATTERY

Battery type: LiFePO4
Battery voltage range [V]: 44V – 58.4V
Recommended battery voltage [V]: 51.2V
Battery Capacity(Ah): 200Ah
Recommended charging/discharging current [A]: 100A
Max.charging/discharging current [A]: 150A
Communication interfaces: RS232 / RS485 / CAN
Design cycle life: Over 5000 cycles (Under certain test conditions)
Parallel operation: Yes, up to 15 batteries, max 76.8 kWh

AC OUTPUT (LOAD)

Nominal AC power [kW]: 4.8kW
Max. AC power [kW]: 6kW
Peak power @5sec [kW]: 9kW (Test with resistive loads only)
Rated grid voltage (AC voltage range) [V]: 220V – 240V ± 2%
Rated grid frequency [Hz]: 45Hz – 60Hz ± 0.05%
Nominal AC current [A]: 22A
Max. AC current [A]: 28A
Switch time[ms]: <4ms(15ms in weak AC source mode)
Total harmonic distortion (THD, linear load) [%]: <3%
Parallel operation: Yes
Load shedding[1]: Yes

PROTECTION

Inverter: Overload / Output short circuit / PV array reverse polarity / PV over voltage / Equipment Over temperature
Battery: Over Current / Over Voltage / Temperature

ENVIRONMENT LIMIT

Protection class: IP20
Operating temperature range [°C]: -10°C – 40°C
Altitude[m]: ≤2000m
Storage temperature[°C]: Recommended 0°C – 35°C
Noise emission(typical) [dB]: <30dB

GENERAL INFORMATION

Dimensions(WxHxD) [mm]: 650×1620×214mm
Weight[kg]: 160kg
Cooling concept: Intelligent air cooling
Topology: Low frequency isolation
Communication: WIFI / Ethernet(RJ45)
Display: LED, APP
Certificate: UN38.3, IEC62619

[1] The AC OUT1 for dual-output models is used to connect critical loads. The AC OUT2 is used to connect to non-critical loads.
When battery discharge/ charge and reaches the lower/upper limit soc, the AC OUT2 will disconnect/connect its load.
User can set the threshold soc respectively through the APP.

DOWNLOADS

• Datasheet
• User Manual